Avaire Forum  

Go Back   Avaire Forum > Public Information > Cutting Tile > How do you cut hole for water line?

Thread: How do you cut hole for water line? Reply to Thread
Your Username: Click here to log in
Image Verification
Title:
  
Message:
Post Icons
You may choose an icon for your message from the following list:
 

Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-23-2009 09:02 AM
Avaire Archive Author: Larry
Date: 6/6/2008 2:13 pm EDT
I used a diamond bit ($35)in my roto-zip to cut through the tile to fit around my toilets. It was slow going, but worked great and I didn't break a tile.
06-23-2009 09:01 AM
Avaire Archive Author: Journeyman
Date: 6/5/2008 4:03 pm EDT
You should know the possible ramifications of using any type of percussion drilling when drilling into something such as a quality porcelain tile.

The fact that Avaire tile is a "floating" floor and is not rigidly bonded to the substrate as conventional ceramic tile would be creates an issue for drilling. The vibration of the tool when using a hammer-drill could easily cause the tiles being drilled to crack and break. Another issue would be that the vibration could serve to dislodge and damage the nearby grout.

The goal here is to access the necessary hole without destroying the related tile.

I personally wouldn't recommend the use of any type of percussion tool.

Rather, I would suggest the use of a proper saw. In this case a coring saw with a diamond rim. The use of water to cool the sawing edge would also be necessary.

Coring saws are available for rent in some areas and a coring saw of this size could easily be used in any 1/2" low rpm drilling machine. The required water can be dispensed from a spray bottle or simply poured from a container.

Typically a coring saw of 1-1/8" diameter will suffice but that should be verified with your local needs.

To purchase such a coring saw would cost approximately $50 and they can be found on the Internet if not available somewhere in local stock.
06-23-2009 09:01 AM
Avaire Archive Author: Chris
Date: 6/5/2008 2:09 pm EDT
Avaire uses a high quailty porcelain tile and can be difficult to drill a large hole.

Make sure you have a drill bit that is made for drilling into porcelain tile and a drill that can operate a the proper speed needed to drill into hard materials.

I've had good luck using a hammer drill starting with an 1/8" drill bit then a 1/4" drill bit and then finishing with 1/2" drill bit.

If this isn't something you have access to maybe a local tool rental shop can help.

let me know how it goes. Thanks
06-23-2009 09:00 AM
Avaire Archive
How do you cut hole for water line?

Author: Angel
Date: 6/4/2008 11:50 pm EDT
Hello, we recently installed our tile in a newly constructed bathroom, now that we have purchased our cabinetry we know where the water lines need to be placed. How do we go about drilling a hole through the tile? We have experimented with many types of blades and so far and have had no luck. Thanks!

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -5. The time now is 01:26 PM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.

(888) 528-2473 Copyright © 2009 : CoMc, LLC All Rights Reserved. ~ Design by Chip Thompson