|06-17-2009 11:01 AM|
Date: 3/11/2008 6:05 pm EDT
I used a 1.25" carbide hole saw, and the first one Made it about a third of the way through before it was warn out. The next one I slowed down my drill press and it seemed to work better, but it still took a toll on the new bit. It did seem to work better to cool the bit with water than oil. But over all it looks awesome, and went together pretty easy, considering it was my first time doing any kind of tile work.
|06-17-2009 11:00 AM|
Date: 2/28/2008 9:44 am EDT
Thanks so much - this is great information.
|06-17-2009 11:00 AM|
Date: 2/27/2008 5:00 pm EDT
You have posed one of the tuffer questions for Do It Yourselfers to overcome. The procedure is easy enough if you have the right tools. Most DIY'ers don't.
The larger hole for the stool flange can be cut by making a series of "plunge cuts" with your tile saw. Locate the position of the hole, draw it out with a Sharpie then go to nagging away at the tile until you have the hole satisfactory. This is better than cutting through the tile if the footprint of the fixture won't hide the cut. The hole doesn't have to be pretty.
The smaller holes are a little more difficult. You can again use your wet saw to grind away at the backside of the tile. You'll have to remove some of the plastic but only what is necessary. Once you have the tile thin enough from your grinding, you can then punch a hole from the topside and tool it nicely. Use a hammer and a screwdriver for example. You will have escutcheons to cover any missteps as long as they aren't too wild.
That is the more remedial way to do it.
A pro would use diamond coring saws (hole cutters) for the smaller holes and a right 4" angle grinder with a diamond blade for the larger stool hole. If you have access to those tools you're in good shape.
Avaire is a quality porcelain tile product which is good for the homeowner but hard to deal with when trying to tool it. To make matters worse Avaire is one of the thickest porcelain tiles on the market. Good when it comes to quality, bad when you have to get a hole through it.
|06-17-2009 10:59 AM|
Date: 2/27/2008 11:57 am EDT
I am installing a Avaire tile floor in a bathroom. There is a pedestal sink with the Hot & cold pipes coming up through the floor. What is the best way to cut holes in the tile for the pipes to go through. Also, the toilet flange has ended up in the center of a whole tile. What is the best way to cut around this flange - cut a whole in the tile or cut the tile in half and cut out the edge of the tile to fit.