Avaire Forum  

Go Back   Avaire Forum > Public Information > Installation > Edge tiles

Thread: Edge tiles Reply to Thread
Your Username: Click here to log in
Image Verification
Post Icons
You may choose an icon for your message from the following list:

Additional Options
Miscellaneous Options

Topic Review (Newest First)
06-24-2009 09:19 AM
Avaire Archive Author: Chris
Date: 11/16/2008 2:30 pm EDT
I installed about 400 sq. feet of avaire tile with lots of perimeter tiles. On the edges, I used a small pry-bar with a small piece of protection material against the toe-kick and dry-wall areas (a thin piece of wood or plastic works well). Just be careful to place the pry-bar against the plastic tray and not the tile itself or it will chip.
06-24-2009 09:18 AM
Avaire Archive Author: Krista
Date: 11/3/2008 2:52 pm EDT
I had the same issue and actually pushed in our cupboard base in a few spots. I found that the dish soap really worked well in these situations and kind of rocking the tile back and forth gently, gradually increasing the pressure and then it would just snap in.
06-24-2009 09:18 AM
Avaire Archive Author: Jonathan
Date: 11/2/2008 0:17 am EDT
Try some soapy water to help lubricate the tabs. Also, it is best to avoid trying to snap all 8 tabs together at once. Starting "cock-eyed" and snapping one side then the other can make it easier too.

Good luck and thanks for purchasing Avaire tile!
06-24-2009 09:18 AM
Avaire Archive
Edge tiles

Author: George
Date: 11/1/2008 9:44 pm EDT
So we're installing our Avaire floor (finally - it's been in the garage for 2 months) anyway, everything is going well except for the edges. I know the videos and instructions show using a prybar to get them snapped but are there any other tricks to make this process any easier. Sometimes I'm prying against drywall or cabinets that seem like they're going to give before the tile snaps. Just curious if anyone has any ideas before I soldier on tomorrow.

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

All times are GMT -5. The time now is 02:14 PM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.

(888) 528-2473 Copyright © 2009 : CoMc, LLC All Rights Reserved. ~ Design by Chip Thompson