Avaire Forum

Avaire Forum (http://www.avairefloors.com/forum/index.php)
-   Installation (http://www.avairefloors.com/forum/forumdisplay.php?f=26)
-   -   Over cut-back (http://www.avairefloors.com/forum/showthread.php?t=281)

Avaire Archive 06-24-2009 02:49 PM

Over cut-back
 
Author: Jim Fremstad
Date: 5/22/2009 2:35 am EDT
after I level a few areas to raise the concrete to the level of the cut-back and fill chipped areas, should I but a poly vinyl 6 mill vapor barrier over the entire area so that 1) the tile slips easier during installation, and 2) to keep the floor heat system out of the tarry adhesive?

Avaire Archive 06-24-2009 02:49 PM

Author: Jonathan
Date: 5/25/2009 8:29 am EDT
I'm not sure if I understand part 2 of the question, but generally speaking, a moisture barrier is not required. In fact, you don't want the tile to move too easily - part of the purpose of the rubber grid is to provide a non-skid function.

Avaire Archive 06-24-2009 02:49 PM

Author: chris
Date: 5/26/2009 8:48 am EDT
Jonathan is correct, you don't need a vapor barrier under Avaire tile. If you are installing a heated floor system, make sure you follow the manufacturers installation instructions. Some are very simple, some very complex. My favorite is Quiet Warmth from MP Global, very easy to install. Hope this helps.


All times are GMT -5. The time now is 06:43 PM.

Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.