Avaire Forum  
  #1  
Old 06-24-2009, 10:09 AM
Avaire Archive Avaire Archive is offline
Archive
 
Join Date: Jun 2009
Posts: 943
Default cutting tile at an angle

Author: Brent
Date: 1/10/2009 1:24 pm EDT
I recently put snap tile down in my spare bath and laudry room. The pattern I used was square to the room easy to do, but had problems cutting straight with the plastic building up and causing it to go off line. These cuts were easily hidden because they went under the base board. Now im laying snap tile in my entryway but its going down in a diagonal patern and im trying to figure out what would be the easiest way to cut these tiles in half from corner to corner. I know i can cover most of the cuts up with the transition cover strips but just would like to get suggestions on what would be big enough and best to cut these tile at an angle.
Reply With Quote
  #2  
Old 06-24-2009, 10:10 AM
Avaire Archive Avaire Archive is offline
Archive
 
Join Date: Jun 2009
Posts: 943
Default

Author: Journeyman
Date: 1/11/2009 1:59 pm EDT
A tile saw?

How did you cut the tiles previously?
Reply With Quote
  #3  
Old 06-24-2009, 10:10 AM
Avaire Archive Avaire Archive is offline
Archive
 
Join Date: Jun 2009
Posts: 943
Default

Author: Brent
Date: 1/11/2009 5:42 pm EDT
I used a tile saw i rented from sunbelt.
Reply With Quote
Reply

Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may post new threads
You may post replies
You may not post attachments
You may edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:24 PM.


Powered by vBulletin® Version 3.8.2
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.

(888) 528-2473 Copyright © 2009 : CoMc, LLC All Rights Reserved. ~ Design by Chip Thompson